Operation 4
Handling loads
WARNING
The shake function remains active for two seconds
following activation.
If the driver simply wants to lift or lower the load
during this time, note that the fork carriage may
move significantly more jerkily with the load than in
normal operation. If the two seconds elapse without
the shake function being used, the fork carriage can
be moved normally again with the load.
The following section shows how the shake
function is activated via the standard assign-
ment for "lifting/lowering" using the different
variants of the operating devices. If the "lift-
ing/lowering" function is assigned differently
on the operating device, the shake function is
activated via this other assignment.
6210_003-089
1
A
B
Joystick 4Plus:
– Move the Joystick 4Plus (1) back and forth
between positions (A) and (B) four times.
Then continue to move the component in
the same way.
Double mini-lever:
– Move the 360° lever (2) back and forth
between positions (A) and (B) four times.
Then continue to move the component in
the same way.
563
68011531 EN - 06/2019 - 02 201
To Next Page
Loading...
