4 Operation
Dynamic Load Control
WARNING
Risk to stability.
If the weight determined by a load measurement
exceeds the permissible residual load capacity of
the truck, the truck cannot be operated safely.
– Do not lift the load higher than 800 mm.
– Set down and reduce the load immediately.
– If necessary, use another truck with sufficient
load-bearing capacity.
NOTE
Lift the load to a height of between 300 mm and
800 mm, since the load must subsequently be
lowered slightly for the weighing process. If
the weighing process establishes that the load
is too heavy, the load must not be lifted higher
than 800 mm. The forks must not touch the
ground.
Pickinguptheloadandcallingupthe
load menu
– Pick up the load safely.
– Press the button
.
The first menu level appears.
– Press the "Load" softkey
.
– Press the "Total load" softkey
.
0,00
0,00
0,00
A total of three load totals can be saved.
The total load is explained here using disk
space
.
–Pressthe
softkey.
218
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
