4 Operation
Attachments
WARNING
Risk of accident due to incorrect labelling!
The use of attachments can result in accidents due
to incorrect or missing labels.
If the truck is not fitted with an attachment-specific
residual load capacity rating plate, and the ope-
rating devices are not marked with the relevant
pictograms, the truck must not be used.
– Only use CE-certified attachments that have
operating instructions and the required labels.
– Have a rating plate stating the residual load
capacity of the respective attachment fitted on
the truck.
– Have the operating devices relabelled.
– Have the hydraulic system adapted to the
requirements of the attachment (e.g. adjust the
pump motor speed) by the authorised service
centre.
NOTE
If the required label is not provided, contact
the authorised service centre in good time.
6219_003-056
1
Plug connectors on the lift mast
– Before assembling the attachment, release
the load from the hydraulic system.
CAUTION
Risk of damage to components!
Open connections of plug connectors (1) can
become dirty. Dirt can enter the hydraulic system.
The plug connectors can become stiff.
– Once the attachment has been disassembled,
seal the plug connectors using the protective
caps.
Mounting attachments
Only competent persons must attach and
connect the power supply to the attachment.
– Observ
e the information provided by the
manufa
cturer or supplier of the attachment
when
doing so.
– After each installation, check the attach-
ment functions prior to initial commission-
ing.
222
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
