4 Operation
Attachments
Special feature for clamping attachments
NOTE
If a clamping attachment is fi
tted, please
observe the following:
•
Depressurising the hydraul
ic circuit for
clamping attachments is pe
rformed in
the same way as opening and c
losing the
clamp.
•
Loosen the clamp locking mechanism; see
the relevant sections related to the clamp
locking mechanism.
•
Push the operating device once in the
"Open" direction.
•
Push the operating devic
eonceinthe
"Close" direction.
Completing the depress
urisation
– After the hydraulics have been depres-
surised, push the
softkey to confirm.
– Switch off the truck.
– Install the attachme
nt.
– Switch on the truck.
The function for depressurising the hydraulics
is inactive. The truck is ready for operation.
– Check and ensure all f
unctions of the
installed attachme
nt.
228
56368011531 EN - 06/2019 - 02
To Next Page
