Still RX20-20L - Page 308

4 Operation
Display messages
If, for example, the reflector or the lift-height
sensor is contaminated, it usually helps to
clean these components.
– Switch the truck off and on again.
– If the message still appears, p
lease contact
the authorised service centre
.
The messages are sorted in ascending order according to their code:
Code
Shown on display Description/possible solution
A2103
Parameter faulty
Collective fault of the parameters
A2305
Fault: Control unit
Collective fault on the control unit
A2545
Actuator error 9:
Actuator breakdown
If no attachment is fitted, this message can be
ignored.
- If there is an attachment fitted, contact the
authorised service centre.
A2801
Monitoring
Process monitoring, p
roc 1
A2802
Monitoring
Process monitoring,
proc 2
A2803
Monitoring
Process monitoring
,proc3
A2804
Monitoring
Process monitorin
g, proc 4
A2805
Monitoring
Process monitori
ng, proc 5
A2806
Monitoring
Process monitorin
g, proc 6
A2807
Monitoring
Process moni
toring, proc 7
A2808
Monitoring
Process moni
toring, proc 8
A2809
Monitoring
Process mo
nitoring, proc 9
A2810
Monitoring
Process mo
nitoring, proc 10
A2811
Monitoring
Process m
onitoring, proc 11
A2899
Monitoring
Collective fault of the process monitoring
A3015
Fault: Brake sensor
Collective fault on the brake sensor
A3027
Fault: Sea
t switch
The seat switch does not open
- Stand up from the driver's seat and sit down
again.
A3035
Fault: Brake fluid
Brake fluid switch
A3143
Check lift height sensor
and reflector
Lift-height sensor measurement error
A3151
Plausibility of shift
function hydraulics
If no attachment is fitted, this message can be
ignored.
- If there is an attachment fitted, contact the
authorised service centre.
294
56368011531 EN - 06/2019 - 02