Topcon HiPer Plus - Page 147

Receiver Problems
1-866-4TOPCON www.topconpositioning.com
5-7
A discrepancy exists
between the
differential standards
used at the Base and
Rover receivers.
Ensure the Base and Rover receivers
use the same corrections input/output
format:
1. Connect your receiver and a
computer and start PC-CDU. See
“Connecting the HiPer+ and a
Computer” on page 2-5.
2. Click Configuration->Receiver
->Ports and set the same input/
output format for both receivers.
The specified link rate
is not compatible with
the link rates the
modem supports.
The link rate is the rate
at which data transmits
over the RF link.
• Change the link rate to that which
your modem supports. See the
modem’s manual for link rate
support information.
• See “Radio Configuration” on
page 2-30 for checking the current
link rate and changing the link rate.
The specified baud rate
is not compatible with
the baud rates the
modem supports.
The baud rate is the
rate at which the
receiver transmits
differential messages
to the modem and vice
versa.
• Change the baud rate to that which
your modem supports. See the
modem’s manual for baud rate
support information.
• See “Radio Configuration” on
page 2-30 for checking the current
baud rate and changing the baud
rate.
The Digisquelch
control at the
transmitting modem is
set incorrectly.
The Digisquelch control at the
transmitting modem should be On and
set to Low.