Topcon HiPer Plus - Page 178

Index
Topcon HiPer+ Operator’s Manual
Index
Connect receiver to computer
using Bluetooth 2-6
using PC-CDU 2-8
using RS232 cable 2-7, 2-44
using USB cable 2-7
Connect receiver to controller 2-40
D
Daisy chain 2-31, A-1
Data recording auto-start 2-28
Delete files 4-12–4-14
Differential corrections
LQ field
3-21
Download
BTCONF 2-43
files 4-8–4-12
firmware 4-24–4-26,
4-27–4-28
FLoader 4-23
indicators 4-11
OAFs 4-17
Dual frequency 1-2
E
EIM 4-7–4-8
Elevation mask 2-25
External components 1-14
External power 2-3, 2-4
F
File creation mode 2-26
File name prefix 2-11, 2-25
Files
Bluetooth module
4-27
delete 4-12–4-14
download 4-8–4-12
flash 4-24, 4-25, 4-27, 4-28
power board 4-24, 4-26
RAM 4-24, 4-25, 4-27, 4-28
select 4-10
Firmware
check version
4-21
files 4-24, 4-27
load 4-23, 4-24–4-26,
4-27–4-28
Flash file 4-24, 4-25, 4-27, 4-28
FLoader 1-8, 4-23
FN key 4-2
change baud rate 4-3
data recording 4-2
information modes 4-2
FN key mode 2-28
see also FN key
G
GPS+ 1-2
GSM
configuration
2-40–2-43
safety C-1
I
Information mode
see also Receiver modes
EIM 4-7
extended 4-7
normal 4-7
sleep 4-20
STAT LED 4-7
zero power 4-20
Initial data collection dynamic mode
2-28
Internal antenna 1-10
offset 3-2, 3-3
setup 3-2
Internal batteries 2-2
charge 2-21
status 2-22
Internal components 1-10
Internal GSM 2-42