Topcon HiPer Plus - Page 9

1-866-4TOPCON www.topconpositioning.com
v
List of Figures
Chapter 1
Introduction ...................................................... 1-1
HiPer+ Receiver ............................................................ 1-1
HiPer+ Radome ............................................................. 1-14
HiPer+ Front Panel ....................................................... 1-15
HiPer+ Back Panel ........................................................ 1-16
Chapter 2
Configuration .................................................... 2-1
PC-CDU Main Screen ................................................... 2-8
Click File->Connect ...................................................... 2-8
Bluetooth and RS232 Connection Parameters .............. 2-9
USB Connection Parameters ......................................... 2-9
PC-CDU Connection Established ................................. 2-10
Configuration->Receiver .............................................. 2-11
Receiver Configuration ................................................. 2-11
Receiver Configuration – MINTER Tab ...................... 2-12
Receiver Configuration – Advanced Tab ..................... 2-13
Advanced Configuration – Multipath Reduction .......... 2-13
Advanced Configuration – Loop Management ............. 2-14
Click Disconnect then Exit ........................................... 2-14
Configuration->Receiver .............................................. 2-15
Select Power Mode ....................................................... 2-16
Select Charger Mode ..................................................... 2-17
Select Power Output Modes – Ports ............................. 2-18
Select Power Output Modes – Slots .............................. 2-19
View Voltages Information ........................................... 2-19
Enable and Apply Power Settings ................................. 2-20