Topcon HiPer Plus - Page 10

List of Figures
Topcon HiPer+ Operator’s Manual
vi
HiPer+ MINTER .......................................................... 2-22
Connection Parameters – MINTER Settings ................ 2-24
Configuration->Receiver .............................................. 2-24
Receiver Configuration – MINTER Tab ...................... 2-25
File->Manual Mode ...................................................... 2-31
Manual Mode – Command Responses ......................... 2-32
PDL Radio Configuration Main Screen ....................... 2-33
PDL Top Left Corner Icon Menu ................................. 2-33
Set Capture Method->Soft Break ................................. 2-34
Click Load .................................................................... 2-34
PDL Identification Tab ................................................. 2-35
PDL Radio Link Tab .................................................... 2-36
PDL Serial Interface Tab .............................................. 2-37
PDL – Click Program ................................................... 2-37
Click Close then Exit .................................................... 2-38
Connection Parameters – Manual Mode Only .............. 2-38
Manual Mode Command Responses ............................ 2-39
Select a Survey Configuration ...................................... 2-41
Base or Rover Radio Configuration ............................. 2-42
Set Base or Rover Cell Phone Parameters .................... 2-42
Bluetooth Module Configuration Main Screen ............ 2-44
Select Communication Port and Click Connect ........... 2-45
BTCONF Identification Tab ......................................... 2-46
BTCONF Parameters Tab ............................................. 2-46
BTCONF Security Parameters ..................................... 2-47
BTCONF Serial Interface Tab ...................................... 2-48
Click Disconnect then Exit ........................................... 2-48
Chapter 3
Setup and Survey ............................................. 3-1
HiPer+ Antenna Offsets ................................................ 3-3
Configuration->Receiver->MINTER ........................... 3-7
Advanced->Multipath ................................................... 3-8
Advanced->Loop Management .................................... 3-8
Rover MINTER Configuration ..................................... 3-9