Tormach 1100M - Page 14

©Tormach® 2023
Specifications subject to change without notice.
Page 14 Tormach 1100M® Operator's Manual (Version 1223A)
For the most recent version, see tormach.com/support
7.6 System File Management 170
7.6.1 Manage System Files 170
About System Files 170
7.6.2 Create Backup Files 170
About Backup Files 171
7.6.3 Restore Backup Files 171
7.6.4 Import and Export the Tool Table 172
Import a .csv File 172
Export the Tool Table as a .csv File 172
BASIC OPERATIONS
175
8.1 Start the Machine 176
8.2 Reference the Machine 176
8.2.1 About Referencing 176
8.3 Jog the Machine 176
8.3.1 About Jogging 177
About Continuous Velocity Jogging 177
About Step Jogging 177
8.3.2 Jog Controls Reference 177
Jogging in PathPilot 177
Jogging with the Keyboard 177
Jogging with the (Optional) JogShuttle 177
8.4 Manually Control the Spindle 178
8.4.1 Change the Spindle Speed Range 178
8.4.2 About the Spindle 178
8.4.3 Spindle Controls Reference 179
8.5 Load G-Code 179
8.6 Set Up Tooling 179
8.6.1 Install a Tool in a Set Screw Tool Holder 179
8.6.2 Install a Tool in an ER Collet Tool Holder 179
8.6.3 Install a Drill Chuck in a Jacobs Taper Arbor 180
8.7 Set Tool Length Offsets 180
8.7.1 About Tool Offsets 180
8.7.2 Touch Off the Tool Length Offsets 180
Set a Known Reference Height 181
Measure Tools Using a Known Reference Height 181
8.7.3 Use an ElectronicTool Setter (ETS) to Measure Tools 182
8.7.4 Use a Height Gauge to Measure Tools 182
8.8 Set Work Offsets 182
8.8.1 About Work Offsets 183
8.9 Operate the Coolant Pump 183
8.9.1 About Coolant 183
FIRST PART TUTORIAL
185
9.1 About This Tutorial 186
TABLE OF CONTENTS