INSTALLATION
IN THIS SECTION, YOU'LL LEARN:
About the installation process required for this machine.
The installation of the base machine takes about four hours, not including items such as a Full Enclosure Kit, a
Power Drawbar, or an Automatic Tool Changer (ATC).
Note: For ease of installation, don't install the chip pans, backsplash/splash guard, enclosure, or
other accessories until after you've lifted the machine onto the Machine Stand.
Before operating the machine in any way, you must read and understand this section.
CONTENTS
4.1 Visual Installation Guide 38
4.2 Before You Begin 39
4.3 Installation Tools and Items 39
4.4 Move the Pallet 39
4.5 Assemble the Machine Stand 39
4.6 Unpack the Machine Crate 41
4.7 Install Core Components 42
4.8 Install Accessory Components 56
4.9 Set Up the PathPilot Controller 109
To Next Page
Loading...
