Tormach 1100M - 1.4 Machine Safety

3. WARNING! Fire Hazard.The machine and its enclosure
are not designed to contain fire or explosions. Only use
materials and coolants that are intended for the specific
machining operation. Never use flammable or explosive
items.Before operating the machine in any way, you
must read all Safety Data Sheets (SDSs) for any
workpiece materials, coatings, coolants, lubricants, and
other consumables used.
4. WARNING! Inhalation Hazard. The machine and its
enclosure do not protect you from airborne particulates.
Chips, dust, and vapors from certain materials can be
toxic or otherwise harmful. Before operating the
machine in any way, you must read all Safety Data
Sheets (SDSs) for any workpiece materials, coatings,
coolants, lubricants, and other consumables used.
5. Personal Protective Equipment:Eyes. Prevent injury by
always wearing protective safety eyewear. Before
operating this machine in any way, you must verify that
your eyewear is impact-resistant and rated for
ANSI787+.
6. Operator Knowledge. Before operating this machine in
any way, you and all other operators must read and
understand all instructions. If you don't, there's a risk of
voided warranty, property damage, serious injury, or
death.
On the Spindle Nose
Figure 1-3: Example of a safety decal on the spindle nose.
1. WARNING! Crush Hazard. Moving parts can entangle,
pinch, or cut you, causing death or serious injury. Before
operating this machine in any way, you must verify that
all body parts, long hair, and clothes are clear of the
machine's extent of motion.
2. WARNING! Cut Hazard. Tools and swarf can cut you.
Only hold tools by the tool holder. Before inserting or
removing tools from the machine, you must verify that
all motion is completely stopped.
1.3.3 Information Decals
Before operating the machine in any way, you must locate and
become familiar with all installed information decals on the
machine and equipment.
Serial Number Plate
The serial number plate is on the side of the electrical cabinet,
near the Main Disconnect switch.
Figure 1-4: Example of the serial number plate on the side
of the electrical cabinet.
1.4 MACHINE SAFETY
Before operating the machine in any way, you must
read and understand this section.
Safe operation of the machine depends on its proper use and
the precautions you take. Only trained personnel — with a
clear and thorough understanding of its operation and safety
requirements — shall operate this machine.
1.4.1 General Shop Safety 24
1.4.2 Operational Safety 25
1.4.3 Electrical Safety 26
1.4.1 General Shop Safety
Verify that only qualified machinery maintenance
professionals install, set up, or perform maintenance on
this machine.
Keep the work area well-lit. Use additional lighting if
needed. The work area should be illuminated to a
minimum of 500 lx.
©Tormach® 2023
Specifications subject to change without notice.
Page 24 Tormach 1100M® Operator's Manual (Version 1223A)
For the most recent version, see tormach.com/support
1: SAFETY