CHAPTER 4 TRANSMISSION SEQUENCE
B-EP Series
4-11
4.2.3.2 BARCODE/2-D CODE FORMAT COMMAND
As in the case of the Bit Map Font Format Command, if communication is interrupted while the
Barcode/2-D Code Format Command is running and no subsequent data is transmitted in the
next transmission, a command error occurs.
If communication is interrupted by the command separator, printing is available when the print
data is retransmitted from the beginning in the next transmission.
[Command transmission and print results (Examples)]
(1) When transmitting print data for two labels as usual,
{AY;+00,1,3|}
{D0230,0480,0200|}
{C|}
{LC;0010,0010,0470,0060,1,2|} 1st label data
{XB00;0200,0050,0,3,02,0,0050,+0000000000,020,1,00|}
{RB00;0000001|}
{XS;I,0001,0000C2011|}
{AY;+00,1,3|}
{D0230,0480,0200|}
{C|}
{LC;0010,0010,0470,0060,1,2|} 2nd label data
{XB00;0200,0050,0,3,02,0,0050,+0000000000,020,1,00|}
{RB00;0000002|}
{XS;I,0001,0000C2011|}
Print result: The 1st label data and 2nd label data are printed in a row.
To Next Page
Loading...
Need help?
General