CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-63
(14) Data string to be printed
Drawing data can be programmed by designating the number of digits after the symbol
“=.”
Up to 255 digits can be printed.
When the number of digits exceeds the maximum number of characters, the excess data
will be discarded.
For the character code table, refer to the character code table mentioned later.
(15) Link field No.
The link field No. can be programmed by designating it after the symbol “;.”
After the link field No. is designated using the Format Command, the data strings are
linked by the Link Field Data Command to draw an image.
Up to 20 fields can be linked.
If the link field exceeds 20 fields, an error occurs.
The following shows an example of linked fields on the two continuous labels.
[Format Command]
[ESC] PV01; ........................ ; 01 [LF] [NUL] : Link field No. 1 is designated.
[ESC] PV02; ........................ ; 03 [LF] [NUL] : Link field No. 3 is designated.
[ESC] PV03; ........................ ; 04 [LF] [NUL] : Link field No. 4 is designated.
[ESC] XB01; ........................ ; 03, 04 [LF] [NUL] : Link fields No. 3 and No. 4 are
designated.
[ESC] PV04; ........................ ; 02 [LF] [NUL] : Link field No. 2 is designated.
[ESC] PV05; ........................ ; 03 [LF] [NUL] : Link field No. 3 is designated.
[ESC] PV06; ........................ ; 04 [LF] [NUL] : Link field No. 4 is designated.
[ESC] XB02; ........................ ; 03, 04 [LF] [NUL] : Link fields No. 3 and No. 4 are
designated.
Designating the link field No.
[Data Command]
[ESC] RV; A [LF] B [LF] ABCD [LF] 001 [LF] [NUL]
Link field No. 4
Link field No. 3
Link field No. 2
Link field No. 1
A
ABCD
001
*ABCD001*
B
ABCD
001
*ABCD001*
To Next Page
Loading...
