CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-64
Notes
(1) The check digit attachment, increment/decrement and zero suppression are performed
according to the following priority. If any of the conditions is improper, no drawing will
take place.
For example, the zero(s) is replaced by a space(s) as a result of zero suppression, but
the modulus 10 designated to be attached cannot be calculated.
Increment/decrement > zero suppression > attachment of check digit
(2) Up to 32 fields for which increment/decrement has been designated can be drawn. If the
total bit map font, outline font and barcode increment/decrement fields exceeds 32,
drawing will take place without incrementing/decrementing any excessive field. The field
to be incremented or decremented is incremented or decremented until the Image Buffer
Clear Command ([ESC] C) is transmitted.
[Examples]
1) Format Command (Incrementing character string No. 01 (+1))
2) Format Command (No incrementing character string No. 02)
3) Format Command (Incrementing character string No. 03 (+2))
4) Image Buffer Clear Command
5) Data Command (Character string No. 01 “0001”)
6) Data Command (Character string No. 02 “AB-”)
7) Data Command (Character string No. 03 “0100”)
8) Issue Command (2 labels)
9) Issue Command (1 label)
10) Image Buffer Clear Command
11) Data Command (Character string No. 02 “00000”)
12) Issue Command (1 label)
0001
AB-0100
0002
AB-0102
0003
AB-0104
00000
To Next Page
Loading...
Need help?
General