CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-84
hh: Wide bar width
01 to 99 (in units of dots)
ii: Wide space width
01 to 99 (in units of dots)
* In the case of industrial 2 of 5, the value is fixed at 00.
jj: Character-to-character space width
01 to 99 (in units of dots)
* In the case of MSI and ITF, the character-to-character space width is fixed at
00.
k: Rotational angle of barcode
0: 0°
1: 90°
2: 180°
3: 270°
llll: Height of barcode
0000 to 1000 (in 0.1 mm units)
mnnnnnnnnnn: Increment/decrement
(Omissible. If omitted, increment/decrement is not performed.)
m: Indicates whether to increment or decrement
+: Increment
-: Decrement
nnnnnnnnnn: Skip value
0000000000 to 9999999999
p: Selection of print or non-print of numerals under bars
(Omissible. If omitted, the numerals under the bars are not printed.)
0: Non-print
1: Print
qq: No. of digits after zero suppression
(Omissible. If omitted, zero suppression is not performed.)
00 to 20
* Reserved in the case of the compatible mode for the B-SP series
r: Designates the attachment of start/stop code
(Omissible. If omitted, the start/stop code is automatically attached.)
T: Attachment of start code only
P: Attachment of stop code only
N: Start/stop code unattached
sss ------ sss: Data string to be printed (Omissible)
Max. 126 digits.
However, the number of digits varies according to the type of barcode.
tt
1
, tt
2
, tt
3
, ------, tt
20
: Link field No. (Omissible)
01 to 99 (1 to 99 can also be used.)
Up to 20 fields can be designated using commas.
To Next Page
Loading...
Need help?
General