CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-88
Example of increment/decrement calculation
Initial value 00000 A0A0A 7A8/9 A2A0A
INC/DEC +1 +1 +3 -3
1st label 00000 A0A0A 7A8/9 A2A0A
2nd label 00001 A0A1A 7A9/2 A1A7A
3rd label 00002 A0A2A 7A9/5 A1A4A
4th label 00003 A0A3A 7A9/8 A1A1A
5th label 00004 A0A4A 8A0/1 A0A8A
(9) Numerals under bars
Numerals are/are not provided under bars according to the parameter for print/non print
of numerals under bars. The numerals under bars to be printed vary according to the
type of barcode.
The font of numerals under bars is OCR-B. These numerals are enlarged or reduced
only horizontally according to the width of the barcode. When they are drawn vertically,
no enlargement or reduction is applied.
[Drawing positions of numerals under bars]
CODE39
(10) Zero suppression
No. of digits after zero
suppression
0 1 2 2 3 4 5
Data 0000 0000 0000 0A12 0123 0123 0123
Print 0000 0 00 A12 123 0123 0123
Zero(s) in a data row is replaced with a space(s) from the upper digits, according to the
designated number of digits. However, if the number of digits after zero suppression is
greater than the data row, the data row will be drawn without performing zero
suppression. Where the data row exceeds the maximum number of digits (40), the data
row will not be drawn.
When the print data including start/stop codes are sent, the start/stop codes are also
counted as a digit each.
(11) Start/stop code
This parameter is effective only when the type of barcode is CODE39 and NW7.
When the parameter is designated, whether or not the stop code and the start code are
attached to the print data to be sent is not checked.
When the parameter is omitted in the case of CODE39 and NW7, a start/stop code will be
attached. The code to be added is “*” in the case of CODE39, and “a” in the case of
NW7.
For details, refer to “AUTOMATIC ADDITION OF START/STOP CODES.”
To Next Page
Loading...
