CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-115
(5) 1-module width
The width of 2 to 6 modules is automatically calculated by designating a 1-module width.
[Example of setting]
203-dpi print head (1 dot = 1/8 mm)
Type of barcode
1 module 2 modules 3 modules 4 modules 5 modules 6 modules
Bar Space Bar Space Bar Space Bar Space Bar Space Bar Space
PDF417 2 4 6 8 10 12
(6) No. of columns/rows
The number of rows and the row length (No. of data strings) are variable. Therefore, the
form of the symbol can be changed in the proportion of the height and width in
accordance with the paper to be used.
The number of columns (the number of data strings) is varied between 1 and 30.
If the number of columns is set to too small though the data volume is large and the
security level is high, drawing may not be performed. This is because the number of
rows may exceed 90 when the number of columns is too small. (The number of rows of
symbols is limited in a range from 3 to 90.)
Values to be set in ff: “1-module width”
To be automatically calculated based
on the value set in ff: “1-module width”
To Next Page
Loading...
Need help?
General