CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-68
(6) An HRI (Human Readable Interpretation) character corresponding to a shift
character and code set character is not printed.
(7) An HRI character for a function character is space.
(8) An HRI character for a control character (00H to 1FH and 7FH) is space.
[CODE93]
The B-EP series does not support the following functions:
(1) An HRI character for a start character () is printed at the beginning of the HRI
character string.
(2) An HRI character for a stop character () is printed at the end of the HRI character
string.
(3) An HRI character for a control character (00H to 1FH and 7FH) is printed with and
an alphabet combined.
Control character
HRI
character
Control character
HRI
character
ASCII Hex ASCII Hex
NUL 00 ■U DLE 10 ■P
SOH 01 ■A DC1 11 ■Q
STX 02 ■B DC2 12 ■R
ETX 03 ■C DC3 13 ■S
EOT 04 ■D DC4 14 ■T
ENQ 05 ■E NAK 15 ■U
ACK 06 ■F SYN 16 ■V
BEL 07 ■G ETB 17 ■W
BS 08 ■H CAN 18 ■X
HT 09 ■I EM 19 ■Y
LF 0A ■J SUB 1A ■Z
VT 0B ■K ESC 1B ■A
FF 0C ■L FS 1C ■B
CR 0D ■M GS 1D ■C
SO 0E ■N RS 1E ■D
SI 0F ■O US 1F ■E
DEL 7F ■T
Reference HRI Character Print Position Set Command ([GS] H)
Barcode Height Set Command ([GS] h)
Barcode Width Set Command ([GS] w)
To Next Page
Loading...
Need help?
General