MachineConfigurations B
Assembly Components
Dual axis body sensor Dual axis body sensor bracket and cable
AS460 dual axis body sensor
Lightbar Lightbar mounting brackets
LB400 lightbar
Data radio Data radio adapter plate, mounting bracket
Data radio
Dual and single GNSS Masts
GNSS receivers
GNSS receiver masts and mast mounting brackets
MS9xx GNSS receivers
Single UTS Mast assembly
Machine target assembly
MT900 machine target mast and mast mounting bracket
MT900 machine target
Cab rotation sensor Heading sensor bracket - weldable mounting plate and bolts
Alignment positioning plate and bolts
HS410 sensor
B.4 Using a laser catcher
You can use an LC450 laser catcher as the stick sensor instead of the AS45x angle
sensor. However, the system will only accept laser strikes if:
l you enable laser catcher support
l the laser catcher is configured as a stick sensor
In the event that an angle sensor fails and a backup laser catcher is available, use
the laser catcher in place of the angle sensor. However, you must disable laser
catcher support.
Note – You can only install one laser catcher on the CAN bus at a time.
For more information, see A.14 Laser catcher support
B.5 Tilt bucket kit
A tilt bucket kit (P/N59706-70) contains the following components:
l Tilt bucket mounting bracket and cables
l AS450 angle sensor
l Tilt bucket cable clamps
GCS900 Grade Control System for Excavators Installation Manual 159
To Next Page
Loading...
