1 About this manual
1.1 Introduction
The Trimble® GCS900 Grade Control System is designed specifically for earth
moving equipment in the construction industry.
Even if you have used other machine guidance systems before, Trimble
recommends that you spend some time reading this manual to learn about the
special features of this product.
1.2 Scope and audience
The intended audience for this manual are personnel who install the system on the
machine. This includes personnel performing the following roles:
l Dealers
l Installation technicians
This manual describes how to install and configure the devices and cables used with
the system. It is assumed that both the GCS900 Grade Control System for
Excavators Operator's Manual and the GCS900 Grade Control System Reference
Manual have been read and understood.
This manual begins by describing the system devices and cables, followed by
information on how to install, calibrate and configure the system, and concludes
with a validation section.
1.3 Related information
Trimble manuals that are related to this product are available in Adobe
®
Portable
Document Format (PDF) on the Trimble GCS900 Grade Control System USB flash
drive.
To view or print the manuals, use Adobe
®
Acrobat
®
Reader (there is a link on the
USB flash drive).
Utilities that do not have an accompanying manual have an integral Help system.
1.4 Training classes and technical assistance
Contact your dealer for:
l Technical support
l Information notes and other technical notes
16 GCS900 Grade Control System for Excavators Installation Manual
To Next Page
Loading...
