8 Installing Fixed Sensor Components
8.5.1 Body, boom and stick angle sensors
Connect the sensor to the appropriate arm or front body harness connector. For more
information, see Figure 5.1 on page 37
8.5.2 Bucket angle sensor
1. Check the installation of the sensor bracket.
2. Connect the sensor to the arm harness cable using the armored cable (P/N
0793-8020-xx).
3. Secure the clamps to each end of the cable.
4. Attach the bracket lid.
8.5.3 Tilt bucket angle sensor
1. Check the installation of the sensor bracket.
2. Connect the sensor to the arm harness cable using the armored cable (P/N
0793-8020-xx).
3. Secure the clamps to each end of the cable.
4. Attach the bracket lid.
8.5.4 Cab rotation sensor
Connect the sensor to the AUXILIARY connector on the rear body harness cable
(P/N 78174) using cable P/N 66899-xx.
82 GCS900 Grade Control System for Excavators Installation Manual
To Next Page
Loading...
