3 Preparingfor anInstallation
3.1 Introduction
Visit the site before the install, so that you save valuable time later. During your
visit, discuss the installation with people on-site, such as the site supervisor,
foreman, and machine operators.
3.2 Visiting the site
When on-site, do the following:
l Identify:
which machine to install the system on.
Note – The system provides accurate guidance to a machine. However, it
cannot turn an old machine with worn linkages into an accurate machine.
Install the system on the best machine available.
where the installation will take place. If possible, install the equipment in
a fully equipped workshop and steam clean the machine before you start.
Installation is easier and faster on a clean machine.
the service mechanic. In the future, this mechanic should service the
system. Decide on the method of mounting the equipment and cables.
the tradespeople you will work with, such as welders and painters.
l Organize any pre-work you want done:
Identify where to weld parts to the machine, and which body panels to
remove.
Determine if you need any custom-made brackets. Take the necessary
measurements and get the brackets made ahead of time.
l Ensure that a welder is available, and that the welder knows the size of plate to
weld. Check if you need to disconnect any electrical cables before the welding
begins.
l Plan the installation of the cables on the machine:
Calculate the length of the planned cable route.
For more information, see 5.2 Cable routing guidelines.
Determine the ease of feeding cables and connectors through the machine.
l For systems that use GNSS, you must make sure that:
there is a GNSS base station on-site that you can use or access to a
Trimble
®
VRS™ system
24 GCS900 Grade Control System for Excavators Installation Manual
To Next Page
Loading...
