Safety Information
Safety Information
Most accidents that involve product operation, maintenance and repair are caused
by failure to observe basic safety rules or precautions. An accident can often be
avoided by recognizing potentially hazardous situations before an accident occurs.
A person must be alert to potential hazards. This person should also have the
necessary training, skills and tools to perform these functions properly.
Improper operation, lubrication, maintenance or repair of this product can be
dangerous and could result in injury or death.
Do not operate or perform any lubrication, maintenance or repair on this product,
until you have read and understood the operation, lubrication, maintenance and
repair information.
Safety precautions and warnings are provided in this manual and on the product. If
these hazard warnings are not heeded, bodily injury or death could occur to you or
to other persons.
The hazards are identified by the “Safety Alert Symbol” and followed by a “Signal
Word” such as “DANGER”, “WARNING” or “CAUTION”. The Safety Alert
“WARNING” label is shown below.
WARNING — This alert warns of a potential hazard which, if not avoided, can cause severe
injury.
The meaning of this safety alert symbol is as follows:
Attention! Become Alert! Your Safety is Involved.
The message that appears under the warning explains the hazard and can be either
written or pictorially presented.
Operations that may cause product damage are identified by “NOTICE” labels on
the product and in this publication.
Trimble® cannot anticipate every possible circumstance that might involve a
potential hazard. The warnings in this publication and on the product are, therefore,
not all inclusive. If a tool, procedure, work method or operating technique that is
notspecifically recommended by Trimble is used, you must satisfy yourself that it is
safe for you and for others. You should also ensure that the product will not be
damaged or be made unsafe by the operation, lubrication, maintenance or repair
procedures that you choose.
The information, specifications, and illustrations in this publication are on the basis
of information that was available at the time that the publication was written. The
specifications, torques, pressures, measurements, adjustments, illustrations, and
other items can change at any time. These changes can affect the service that is
GCS900 Grade Control System for Excavators Installation Manual 5
To Next Page
Loading...
Need help?
General