USTER HVI 900 - Page 140

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-5
3.4.6 Printer
This selection is used to indicate whether the test results will be sent to a
printer. It alternates between No and Yes using the ENTER key.
• No — Test results are not sent to the printer.
•
Yes —Test results will be sent to the printer.
3.4.7 Print Mode
This field is used to select the type of data that will be printed from the
test results. The options include the following and are selected using the
ENTER key.
• Averages — Only the average of all the repetitions will be printed.
• Individual Tests — The data for each individual test will be
printed.
• Extended Measurements — Addition calculations for work
peak, work total, percent crimp, and modules will be printed.