USTER HVI 900 - Page 148

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-13
3.6.1 Exiting Length/Strength Module
Testing
When you are finished with Length/Strength Module Testing use the
following steps to exit the screen.
• After a test series is complete, a blank Test Results Screen is
displayed requesting that you either "Enter ID" or supply the
micronaire value (if required). Press: ENTER at "Enter ID" (if
required).
•
If entering the fineness value via the keyboard, "Enter Fineness" is
displayed. Enter any value between two (2) and eight (8). If the
value is to be determined via the micronaire test, "Weight from 8.5
to 11.5 grams of fiber. Mass" is displayed. Press: ENTER. "Enter"
is displayed. Type any value between two (2) and eight (8), then
press ENTER. Once a value has been entered, the Operations
options are displayed.
— Press ESCAPE to exit
— Press <! > To reject (To reject the last test)
—
Press <#> to set motors
• Press ESCAPE exiting.