USTER HVI 900 - Page 150

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-15
4.4.2 Identifier
This information is not required and may already be provided if the ID
was entered during another module test. You can proceed to Continue
with Testing
without entering information in the Identifier field.
However, if this item is selected, it becomes required and a value must
be entered before continuing. You can enter up to 30 alphanumeric
characters to define the lot or merchant for a particular group of
samples.
As with other modules, the Identifier entered remains in effect until the
next time the Identifier field is changed in another module.
• When you have entered the Identifier information, press ENTER to
exit the instruction statement.
4.4.3 Number of Tests
This selection is used to indicate the number of Micronaire tests that are
to be performed on each sample (maximum: 10 per sample).
• Enter the desired number of tests, then press ENTER.
• The number entered here does not affect the number entered in
Status Mode for System Testing.
4.4.4 Printer
This selection alternates between Off, On, and Averages using the
ENTER key.
•
Off — No test results will be sent to the printer; the information will
only be displayed on the screen.
• On — All test results will be sent to the printer.
• Averages — Only the averages of the test results will be sent to the
printer.