USTER HVI 900 - Page 152

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-17
• Means - The mean value of the total number of tests for each
module will be transmitted. Using the example above, the mean
value of the two Length/Strength tests would be transmitted rather
than individual data for each (two) Length/Strength test.
• Standard Deviations - The standard deviation of the total number
of observations will be transmitted.
• % CVs - The percent CV of the total number of observations will be
transmitted.
When you ESCAPE from the TRANSMISSION TYPE MENU after selecting
one or more of the items on the menu, the External Compute r is
automatically turned "ON."
When External Computer is "ON," two additional items are displayed
on the LEN/STRENGTH SAMPLE TESTING MENU. They are Reject Sample to
Computer/DataManager and Sign-off External Computer. If the
External Computer is ON, the reject is displayed. Neither is displayed if
both are OFF. Each is described below.
4.4.6 Reject Sample to
Computer/DataManager
When the test results for the last sample tested should be rejected,
ESCAPE from the Module Testing Screen, and select
Reject Sample to
Computer/DataManager . This sends a signal to the external computer
and/or to DataManager that the previous sample tested is to be
rejected. The test results for the rejected sample will not be included in
any mathematical analyses performed on the samples listed for that
identifier.
Immediately upon selecting
Reject Sample to Computer/ DataManager ,
the test results for the last sample are rejected. If a problem occurs
while transmitting the data, the error message “Computer Not
Responding” is displayed on the screen.