USTER HVI 900 - Page 158

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-23
5.4.2 Identifier
This information is not required and may already be provided if the ID
was entered during another module test. You can proceed to Continue
with Testing
without entering information in the Identifier field.
However, if this item is selected, it becomes required and a value must
be entered before continuing. You can enter up to 30 alphanumeric
characters to define the lot or merchant for a particular group of
samples.
As with other modules, the Identifier entered remains in effect until the
next time the Identifier field is changed in another module.
• When you have entered the Identifier information, press ENTER to
exit the instruction statement.
5.4.3 Number of Tests
This selection is used to indicate the number of Color and Trash tests
that are to be performed on each sample (maximum: 10 per sample).
• Enter the desired number of tests, then press ENTER.
The number entered here does not affect the number entered in Status
Mode for System Testing.
5.4.4 Trash Measurement
This selection alternates Off and On.
• Off — No trash test will be made by the trashmeter.
•
On — The trashmeter will test the sample and the results will be
displayed on the screen.