USTER HVI 900 - Page 24

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 1
Version 4.0 (1.99) Introduction - Page 1-12
7.5.2 Length/Strength Cabinet
An equipment label is located on the
rear enclosure (behind the rear doors).
A label is located on the brushing
assembly indicating where the
pinch hazard could occur if your
hand is in the area of the brusher.
The door should remain closed
during length/strength
measurement operations.
A label is located on the comb
track assembly indicating the
where a crush hazard could occur
if your hand is in the area of the
comb transport. The door should
remain closed during
length/strength measurement operations.
A label is located on the comb
transport assembly indicating where
a crush hazard could occur if your
hand is in the area of the comb
transport. The instrument should not
be operated with the cover raised.