USTER®
HVI 900
Instruction Manual
Uster Technologies, Inc.
Chapter 1
Version 4.0 (1.99) Introduction - Page 1-13
A warning label with the
hand/wire/flash is located on the
top of the power distribution box
(control box). This indicates that
hazardous voltage is under this
cover. Operators should NEVER
be allowed in here.
This label is also located on the frame of the instrument behind each of
the front and rear cabinet doors.
The label with a flash symbol inside a triangle is
located inside the power distribution box on top
of the power connector blocks on the plastic
shield. This indicates to the service person
that hazardous voltage exists behind this
cover.
The warning label portraying a hand being cut
is located on the breaker arm in the rear of the
length/strength cabinet. This indicates a
shearing hazard if the instrument is operated
with the interlock switch defeated.
To Next Page
Loading...
