USTER HVI 900 - Page 329

USTER® HVI 900 SA Instruction Manual
Uster Technologies, Inc. Chapter 16
Version 4.0 (1.99) Index - Page 16-7
Define Categories, 14-21
Define Categories to Cover the Range of Your Cotton, 14-21
How the Category System Works, 14-16
How to Determine the Average and Range of a Spinning Mill's Inv, 14-17
Initial Analysis of the Inventory, 14-19
Initial Category Definition for Inventory Analysis, 14-18
Why Category Definitions Should Remain the Same, 14-17
Installation, 2-1
Compressed Air, 2-3
Connections, 2-5
Electrical Power Requirements, 2-2
Fibrosampler 192, 13-7
Floor Space Requirements, 2-4
International Calibration Cottons, 14-8
Interval, 9-3
Introduction, 1-1
HVI 900 Equipment, 1-1
HVI 900 System Modules, 1-4
Keyboard Commands, 1-9
K
Keyboard Commands, 1-9
Changing Selections/Parameters, 1-9
Exit From Operation, 1-9
Special Function Keys, 1-11
Visual Cues Used in This Manual, 1-10
L
Leaf, 6-7, 7-8
Len 1, 10-7
Len 2, 10-7
Length (Len), 7-9
Length and Strength Calibration Menu, 5-3
Length and Strength Calibration Status Menu, 5-4
Calibration Mode, 5-5
HVI, 5-5
ICC, 5-5
ICC SL1 %, 5-5
ICC SL2 %, 5-6
Length and Strength Cotton Standard Values Menu, 5-8
Length Units, 5-5
Length/Strength Calibration Constants, 5-6
Length/Strength Calibration Cotton Standard Values, 5-8
Length/Strength Calibration Status Menu, 5-8
Length and Strength Lens to Break Test Results, 5-14
Length and Strength Lens to Break Test Screen, 5-14
Length Standard Calibration, 5-10
Length Standard Calibration Menu, 5-9
Length Standard Calibration, 5-10
Length Standard Check, 5-12
Length Standard Test Results Screen, 5-11
Length Standard Value, 5-12