YASKAWA E-7S SERVOPACK SGD7S

16.2 List of Parameters
16.2.2 List of Parameters
16-9
16
Parameter Lists
Pn00A
2
Application Function
Selections A
0000h to
1044h
–
0001h All
After
restart
Setup
–
Pn00B
2
Application Function
Selections B
0000h to
1121h
–
0000h All
After
restart
Setup
–
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
Motor Stopping Method for Group 2 Alarms Reference
0
Apply the dynamic brake or coast the motor to a stop (use the
stopping method set in Pn001 = n.X).
page 5-36
1
Decelerate the motor to a stop using the torque set in Pn406 as
the maximum torque. Use the setting of Pn001 = n.X for the
status after stopping.
2
Decelerate the motor to a stop using the torque set in Pn406 as
the maximum torque and then let the motor coast.
3
Decelerate the motor to a stop using the deceleration time set in
Pn30A. Use the setting of Pn001 = n.X for the status after
stopping.
4
Decelerate the motor to a stop using the deceleration time set in
Pn30A and then let the motor coast.
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X
Operator Parameter Display Selection Reference
0 Display only setup parameters.
page 5-3
1 Display all parameters.
n.X
Motor Stopping Method for Group 2 Alarms Reference
0 Stop the motor by setting the speed reference to 0.
page 5-361
Apply the dynamic brake or coast the motor to a stop (use the
stopping method set in Pn001 = n.X).
2 Set the stopping method with Pn00A = n.X.
n.X
Power Input Selection for Three-phase SERVOPACK Reference
0 Use a three-phase power supply input.
page 5-13
1
Use a three-phase power supply input and as a single-phase
power supply input.
n.X Reserved parameter (Do not change.)