16.3 Parameter Recording Table
16-40
*1. This parameter is automatically set when the INDEXER Module is mounted to the SERVOPACK. Do not change
the setting. Refer to the following sections for details.
16.2 List of Parameters on page 16-3
*2. The enable timing depends on the digit that is changed. Refer to the following section for details.
16.2 List of Parameters on page 16-3
PnB4F
0000h ZONE Signal Setting After restart
PnB50
0 Backlash Compensation Immediately
PnB51
0 /ALO Output Selection After restart
PnB52
0 /ALM-RST After restart
PnB53
0050h
Input Signal Monitor IN1
Polarity Selection
After restart
PnB54
0
Speed/Position Expansion
Function Selection
After restart
Continued from previous page.
Parameter
No.
Default
Setting
Name
When
Enabled
To Next Page
Loading...
