Yealink VC880 - Taking Screenshots; Configuring Video Recording

| Configuring Basic Settings | 121
2. Configure and save the following settings:
Parameter Description Configuration Method
Screenshot
Enable or disable to capture the
screenshot by using the remote
control.
• On
• Off
Default: On.
Web user interface
• Taking Screenshots
Related tasks
Configuring USB Storage
Configuring Local Storage
Taking Screenshots
Procedure
Do one of the following:
• On your web user interface, go to Home > Screenshot.
•
On your remote control, if is set to the Screenshot key, press to capture screenshot.
• On your CP960 conference phone, go to More > Screenshot.
•
In the top-right corner of your CTP20, tap , select Screenshot on host.
Configuring Video Recording
You can record the video.
Before you begin
If you want to record the video to USB flash drive, make sure the USB flash drive is available.
If you want to record the video to the local storage (is only applicable to VC200/VP59), make sure you
enable the local storage.
Procedure
1. On your web user interface, go to Setting > Video & Audio > USB Config.
2. Configure and save the following settings:
Parameter Description Configuration Method
Recording
Enable or disable the video recording feature
on the system.
Default: On.
Web user interface