Yealink VC880 - Configuring VLAN Manually

| Configuring Network Settings | 68
Configuring LLDP
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Advanced > LLDP.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced
Network > LLDP.
On your VC200, go to More > Network > Wired Network > Advanced Network > LLDP.
On your VP59, tap Setting > Advanced > Advanced Network > LLDP.
• On your CTP20, tap Setting > Advanced > Advanced Network > LLDP.
2. Configure and save the following settings:
Parameter Description Configuration Method
Active
Enable or disable the LLDP
feature on the system.
Note: the default value is Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Packet Interval(1-3600s)
Configure the interval (seconds)
for the system to send LLDP
requests.
Default: 60 seconds. The value
can be any integer from 1 to
3600.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Configuring VLAN Manually
VLAN is disabled on systems by default. You can configure VLAN for the Internet port manually. Before
configuring VLAN on the system, you need to obtain the VLAN ID from your network administrator.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Advanced > VLAN > Internet Port.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced
Network > VLAN.
On your VC200, go to More > Network > Wired Network > Advanced Network > VLAN.
On your VP59, tap Setting > Advanced > Advanced Network > VLAN.
• On your CTP20, tap Setting > Advanced > Advanced Network > VLAN.