| Configuring Video Settings | 139
Display Layout Settings
• Setting the Default Layout for a Single Screen
• Configuring Change Layout by Content Sharing
• Hiding Local Video Image in Equal Layout
• Configuring Hide Local Video When PIP
• Configuring Multi-Camera Default Layout
• Configuring Voice Activation
• Configuring the View Switching
• Configuring Preview Local
Setting the Default Layout for a Single Screen
When only one monitor is connected to the system, you can configure the default layout when a call is
established.
About this task
For VP59, if you do not connect a monitor to it, it is single screen by default.
Procedure
1. On your web user interface, go to Setting > Call Features > Layout > Default Layout of Single
Screen.
On your VP59, go to Setting > Call Features > Default Layout.
2. Configure and save the following settings:
Parameter Description Configuration Method
Default Layout of
Single Screen
Configure the default layout of single screen
when a call is established.
• Remote big Local small—the remote
video image is shown in the big size, and
the local video image below is shown in
the small size.
• Remote Full screen—the remote video
image is shown in full size.
• Equal NxN—the remote and local video
images are shown in the same size.
• Picture in Picture—the remote video
image is shown in full screen, and local
video image is shown in the PIP (Picture-
in-Picture). (it is not applicable to VP59)
Default: Picture in Picture. For VP59, the
video image of the remote party is displayed
in large window and the local video image is
displayed in small window.
Web user interface
To Next Page
Loading...
