Yealink VC880 - Adjusting Hangup Mode and Camera Pan Direction

| Configuring Camera Settings | 165
Parameter Description Configuration Method
Noise Reduction (2D)
Specify the noise reduction (2D)
mode.
The available modes are
described as below:
• Off
• Low
• Middle
• High
Default: Middle.
Web user interface
Endpoint
CTP20
Noise Reduction (3D)
Specify the noise reduction (3D)
mode. It indicates the coefficient
of the reduced noise in the
image. The higher the coefficient
is, the smaller the noise is.
Valid value: 0 - 22. The default
value is 3.
Web user interface
Endpoint
CTP20
Adjusting Hangup Mode and Camera Pan Direction
To display high quality video image, you can adjust camera settings as required, such as white balance,
exposure and sharpness. This feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Other Settings.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera Setting >
Graphics.
On your VC200, go to More > Setting > Video & Audio > Graphics.
• On your CTP20, tap Setting > Camera > Other.
2. Configure and save the following settings:
Parameter Description Configuration Method
Hangup Mode
Enable or disable the camera
to flip the image view when
camera is hung at up-side-down
position.
If this mode is enabled, the
picture took by the camera
is upside down. This mode is
applicable when you install the
camera on the meeting room
ceiling.
Default: Off.
Web user interface
Endpoint
CTP20