| Configuring Content Sharing | 151
Configuring Mix-Sending
During a call, the device of the remote party may not support dual-stream protocol. Therefore, you need
enable this feature, so that multiple video streams (the local video + the local content) can be synthesized
to one video stream and sent to the remote.
Procedure
1. On your web user interface, go to Setting > Video & Audio > Presentation.
2. Configure and save the following settings:
Parameter Description Configuration Method
Mix
Enable or disable the mix-
sending feature on the system.
Note: the default value is On.
Web user interface
Note: If both parties enable the dual-stream protocol, the dual-stream protocol will be used to
send multiple video streams.
Configure Content Sharing
You can configure whether to enable PC presentation on the system when the content is sharing. You can
also specify the mode, the maximum frame and the resolution for the shared content. Make sure that the
definition of the presentation is good. You can not configure the content sharing mode for VP59, but you
can configure frame and resolution for VP59.
Procedure
1. On your web user interface, go to Setting > Video & Audio > Content Sharing.
2. Configure and save the following settings:
Parameter Description Configuration Method
Content Sharing Mode (it is not
applicable to VP59)
Configure the content sharing
mode.
• Sharing Document- select
this value to save bandwidth
when you are sharing a
document. By default, the
maximum frame rate is 15fps
and the maximum resolution
is 1080P.
• Sharing Video: select this
value to play video fluently
when you are sharing a video.
By default, the maximum
frame rate is 30fps and the
maximum resolution is 720P.
Default: sharing document.
Web user interface
To Next Page
Loading...
