| Configuring Camera Settings | 167
Setting the Camera Presets
Camera presets are pre-saved values of the angle and the focal length of the camera with respect to the
desired positions. The camera presets can help you quickly point a camera at pre-defined locations. The
camera presets can remain in effect until you change them. This feature is not applicable to VP59.
Procedure
1.
On your web user interface, go to Home > Yourself > .
2. Click any number to configure the camera presets.
You can add, modify, and delete the preset.
Note: For more information about configuring presets via CP960 conference phone, CTP20 or
the remote control, refer to the Yealink Full HD Video Conferencing System User Guide.
Allowing the Remote System to Control Your Camera
You can allow the far site to control your camera, so that the far-end can meet their watching need.
To allow the far site to control your camera, meet the following conditions:
• Enable the protocol of camera control.
• Enable the feature of far control near camera (it is not applicable to VP59).
Note: Note that during a call, you can use your VP59 to control the far-end camera, but the far-end
cannot control the camera of your VP59.
• Camera Control Protocol
• Configuring the Far Site to Control the Near Camera
Camera Control Protocol
If far site wants to control your camera, both the far site and you should enable the camera control
protocol simultaneously. Your system supports FECC (Far End Camera Control) protocol. You can enable the
FECC(H.323) protocol for the H.323 call and enable FECC(SIP) protocol for the SIP call.
• Configuring FECC (H.323) Protocol
• Configuring FECC (SIP) Protocol
To Next Page
Loading...
