Yealink VC880 - Viewing the Connected Devices; Adding Connected Devices to the Blacklist

| Configuring Network Settings | 63
Parameter Description Configuration Method
AP IP Address
Configure the generation type of
wireless AP address.
• Auto—generates the wireless
AP address automatically. The
default network segment is
192.168.144.X.
• Manual—If automatically
generated network segment
conflicts with the one you
use, you can change the
network segment manually.
Default: Auto.
Web user interface
IP Address
Configure the IP address of the
wireless AP.
Only when the AP IP Address
is manual do you need to
configure this parameter.
Web user interface
Viewing the Connected Devices
Procedure
1. Do one of the following:
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP >
AP Device List.
On your VC200, go to More > Network > Wireless AP > AP device list.
On your VP59, tap Setting > Network & Connection > Wireless AP > AP device list.
• On your CTP20, tap Setting > Advanced > Network > Wireless AP > AP Device List.
2. View the names and the MAC addresses of the connected devices.
Adding Connected Devices to the Blacklist
You can add connected devices to the blacklist, and the device is disconnected from the wireless AP.
Procedure
1. Do one of the following:
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP >
AP Device List.
On your VC200, go to More > Network > Wireless AP > AP device list.
On your VP59, tap Setting > Network & Connection > Wireless AP > AP device list.
• On your CTP20, tap Setting > Advanced > Network > Wireless AP > AP Device List.
2. Select the desired device.
The monitor prompts “Move the device into blacklist?”.