| Configuring Network Settings | 62
2. Configure and save the following settings:
Parameter Description Configuration Method
AP Name Configure the name of wireless
AP.
Web user interface
Endpoint
CTP20
Security Mode
Configure the security mode of
the wireless AP.
• None
• WPA2-PSK
Default: WPA2-PSK.
Web user interface
Endpoint
CTP20
Password
Configure the password of the
wireless AP.
Note: only when the security
mode is WPA2-PSK do you need
to configure this parameter.
Web user interface
Endpoint
CTP20
Network Sharing
Enable or disable the system to
share its wired network to the
connected devices.
• On—The connected
devices can use an Internet
connection.
• Off—The connected devices
cannot use an Internet
connection.
Default: Disabled.
Web user interface
Frequency
Configure the frequency of the
wireless AP.
• 2.4G
• 5G
Default: 5G.
Web user interface
Endpoint
CTP20
Channel
Configure the channel of the
wireless AP.
Default: Auto.
Web user interface
Endpoint
CTP20
To Next Page
Loading...
