| Configuring the Meeting Room | 169
Configuring the Far Site to Control the Near Camera
You can enable this feature to allow the remote to control your local camera, so that the image captured by
the local camera can be displayed properly on the remote monitor. This feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Video & Audio > Far Control Near Camera.
• On your VCS, go to More > Setting > Video & Audio.
• On your CTP20, tap Setting > Camera.
2. Configure and save the following settings:
Parameter Description Configuration Method
Far Control Near Camera
Enable or disable the far site to
control the near-site camera.
Default: On.
Web user interface
Endpoint
CTP20
Reset Camera
You can reset the camera to factory defaults.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Other Settings.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera Setting > Other .
On your VC200, go to More > Setting > Video & Audio > Other .
• On your CTP20, tap Setting > Camera > Other.
2. Select Reset Camera.
The system prompts whether or not you are sure to reset.
3. Confirm the action.
Configuring the Meeting Room
Yealink video conferencing system can act as a virtual meeting room, so that other devices can dial
the system to join a meeting. Your system supports the following two conference types: regular mode
conference room and virtual meeting room. You can configure the conference type and set the meeting
password for the conference. This feature is not applicable to VP59.
You can also configure the third-party virtual meeting room to make multi-party video calls.
Note:
If you log into the Yealink VC Cloud Management Service, the conference may be managed via the
Yealink VC Cloud Management Service only, you cannot configure it on your system.
• Conference Types
To Next Page
Loading...
