| Configuring Camera Settings | 156
Configuring Auto Exposure Mode
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Exposure.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera > Exposure.
On your VC200, go to More > Setting > Video & Audio > Exposure.
• On your CTP20, tap Setting > Camera > Exposure.
2. Select Auto from the Exposure drop-down menu.
3. Configure and save the following settings:
Parameter Description Configuration Method
Exposure Compensation
Configure the value of exposure
compensation.
The exposure compensation is
used to compensate the camera
effectively when the camera is
shooting in the backlighting.
If the environment light is
dark, you can increase the
compensation value.
Valid value: from -6 to 6. The
default value is 0.
Web user interface
Endpoint
CTP20
Flicker
Configure the value of camera
flicker frequency.
The supported types are as
follows:
• 50 Hz
• 60 Hz
The indoor lights powered by a
50Hz or 60Hz power source may
produce a flicker. You can adjust
the camera flicker frequency
according to the power source
that the light is powered by.
Default: 50 Hz.
Web user interface
Endpoint
CTP20
Gain
Specify the value.
Note: the valid value is 1 to 15.
The default value is 4.
Web user interface
Endpoint
CTP20
To Next Page
Loading...
