Yealink VC880 - Configuring the H.239 Protocol; Configuring BFCP (Binary Floor Control Dual Protocol)

| Configuring Content Sharing | 150
Configuring the H.239 Protocol
H.239 protocol is used when sharing content with the far site in H.323 calls. You can configure the H.239
protocol for the StarLeaf platform or H.323 account.
Procedure
1. On your web user interface, go to Account > VC Platform > Platform Type > StarLeaf or Account >
H.323.
2. Configure and save the following settings:
Parameter Description Configuration Method
H.239
Enable or disable the H.239
protocol.
Default: On.
Web user interface
Configuring BFCP (Binary Floor Control dual Protocol)
BFCP is used when sharing content with the remote in SIP calls. You can configure the BFCP protocol for
Zoom, Pexip, BlueJeans, EasyMeet or a custom third-party platform, SIP account, and SIP IP call.
Procedure
1. Do one of the following:
• On your web user interface, go to Account > VC Platform > Video Conference Platform >
Platform Type > Zoom/Pexip/BlueJeans/EasyMeet /Videxio/Custom.
• On your web user interface, go to Account > SIP Account/SIP IP Call.
2. Configure and save the following settings:
Parameter Description Configuration Method
BFCP
Enable or disable the BFCP.
Note:
For Zoom/Pexip/BlueJeans/
EasyMeet/Videxio/Custom and
SIP IP call, BFCP is enabled by
default.
For SIP account, BFCP is disabled
by default.
This feature is not applicable to
Yealink StarLeaf Cloud platform.
Web user interface
Related tasks
Configuring Mix-Sending