| Configuring the Meeting Room | 172
3. Configure and save the following settings:
Parameter Description Configuration Method
Multipoint AllocationVirtual
Meeting Room 1
Allocates the maximum ways of
video calls for virtual meeting
room 1.
Web user interface
Multipoint AllocationVirtual
Meeting Room 2
Allocates the maximum ways of
video calls for virtual meeting
room 2.
Web user interface
Configuring Meeting Password
Depending on how a conference call is set up, you might be required to enter a meeting password to
join a conference. You can also require the far site to enter a meeting password to prevent unauthorized
participants from joining conference calls hosted by your system. If you host a regular mode conference,
you only need to set the password for virtual meeting room 1. If you host a VMR mode conference, you
need to configure the password for virtual meeting room 1 and virtual meeting room 2 respectively. This
feature is not applicable to VP59.
Procedure
1. On your web user interface, go to Setting > Built-in MCU Setting > Conference Setting.
2. Configure and save the following settings:
Parameter Description Configuration Method
Virtual Meeting Room 1 >
Meeting Password
Enable or disable the system to
configure a password for virtual
meeting room1.
Default: Disabled.
Web user interface
Virtual Meeting Room 1 >
Password
Configure the password for
virtual meeting room 1.
Valid Value: 1 to 10, default
value: 6.
Web user interface
Virtual Meeting Room 2 >
Meeting Password
Enable or disable the system to
configure a password for virtual
meeting room 2.
Note: the default value is Off.
Only when the meeting room
type is VMR mode can this
parameter be configured.
Web user interface
To Next Page
Loading...
