Yealink VC880 - Viewing Camera Status

| Configuring Camera Settings | 153
2. Configure and save the following settings:
Parameter Description Configuration Method
Camera Configure the desired camera.
Web user interface
Status
Enable or disable the selected camera.
Default: On.
It is not applicable to VC200/VC500/PVT950.
Web user interface
Select a Camera
Customize the camera name.
Web user interface
Viewing Camera Status
This feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Camera Info.
• On your VCS, go to More > Status > Camera.
• On your CTP20, tap Setting > Camera > Camera Details.
2. You can view the following camera status:
Parameter Description Configuration Method
Select a Camera Customize the camera name. Web user interface
Model The VCS codec model.
Endpoint
CTP20
IP The IP address of the selected
camera.
Web user interface
Firmware Version The firmware version of the
selected camera.
Web user interface
Hardware Version The hardware version of the
selected camera.
Web user interface
SPEC The specification of the selected
camera.
Web user interface
Endpoint
CTP20
MAC The MAC address of the selected
camera.
Web user interface
Camera Hardware The hardware version of the
camera lens.
Web user interface
Endpoint
CTP20