| Configuring Video Settings | 141
2. Configure and save the following settings:
Parameter Description Configuration Method
Hide Local Video When PIP
Enable or disable the local video
image to hide in the PIP (Picture-
in-Picture).
• On—the local video image is
hidden in the PIP.
• Off—the local video image is
shown in the PIP.
Default: Off.
Web user interface
Configuring Multi-Camera Default Layout
During a call, if you connect VCC22, all the local video streams are synthesized to one video stream, and
sent to the far site. You can configure the default layout when you connect multiple cameras and set the
camera you want to highlight.
Procedure
1. On your web user interface, go to Setting > Camera > Camera.
2. Configure and save the following settings:
Parameter Description Configuration Method
Multi-camera Default Layout
Configure the default camera
layout when you use multiple
cameras.
The supported layouts are
described as below:
• 1+N
• Selected Speaker
• Average
Note: the default value is 1+N.
It is not applicable to VC200/
VC500/PVT950.
Web user interface
Select a camera
Select the camera you want to
highlight.
Note:
The first connected camera.
This configuration appears only
if Multi-camera Default Layout
is set to 1+N or Selected
Speaker.
It is not applicable to VC200/
VC500/PVT950.
Web user interface
Note: It is not available if you only connect one VCC22 to the system and you disable the main
camera or the connected VCC22.
To Next Page
Loading...
