Yealink VC880 - Yealink Meeting Server Usage; Dialing YMS Accounts

| Configuring Network Settings | 58
Parameter Description Configuration Method
Gateway
Configure the IPv6 default
gateway.
Note: It is configurable only
when the network type is
selected as Static IP.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Static DNS
Enable or disable DNS feature.
Default: Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Primary DNS/DNS Primary
Server
Configure the primary DNS
server assigned to the system.
Note: In the DHCP environment,
it is configurable when the static
DNS feature is enabled. If you
change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Secondary DNS/DNS
Secondary Server
Configure the secondary DNS
server assigned to the system.
Note: In the DHCP environment,
it is configurable when the static
DNS feature is enabled. If you
change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Wi-Fi
For VC880/VC800/VC500/PVT980/PVT950, you need to connect a WF50 Wi-Fi USB Dongle to the system
for connecting to the wireless network. You can connect the VC200/VP59 to the wireless network directly.
• Connecting to the Wireless Network
• Viewing the Wireless Network Status
• Forgetting a Wireless Network
• Disabling the Wi-Fi Feature
Connecting to the Wireless Network
There are two ways to connect to the wireless network:
• Manually connect to an available wireless network
• Manually connect to a hidden wireless network