| Configuration Methods | 37
• Using Web User Interface
• Using VCR11 Remote Control
• Using CTP20 Touch Panel
• Using CP960 Conference Phone
Using Web User Interface
A web-based interface is especially useful for remote configuration. You can use the web user interface to
perform most of the calling and configuration tasks.
• Logging into the Web User Interface
• Configuring the Web Server Type
• User and Administrator Account Login
Logging into the Web User Interface
To log on to your device web user interface, you must open a web browser and enter the device IP address.
Login credentials are required for accessing the web user interface. The default administrator username is
“admin” (case-sensitive) and password is “0000”.
Note: We recommend that you use the Chrome or Internet Explorer 11 to access the web user
interface. Some features may not work properly if you are using other or older browsers.
1. Open a web browser and enter the device IP address in the address bar.
2. Enter the administrator username and the password.
3. Click Login.
Attention: The web user interface will be locked after 3 failed login attempts. Please contact
your support team or try again 3 minutes later.
Related tasks
Configuring the Web Server Type
User and Administrator Account Login
Configuring the Web Server Type
The web server type determines the protocol used for accessing the web user interface of the system. Both
HTTP and HTTPS are available. The HTTPS ensures that the configuration of all login information (such as
user names and passwords) is transmitted using an encrypted channel. If you disable the desired protocol,
you cannot access the web user interface via this protocol.
Procedure
1. Do one of the following:
• On your web user interface, go to Network > Advanced > Web Server.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced
Network > Web Server Type.
On your VC200, go to More > Network > Wired Network > Advanced Network > Web Server
Type.
On your VP59, tap Setting > Advanced > Advanced Network > Web Server Type.
• On your CTP20, tap Setting > Advanced > Advanced Network > Web Server Type.
To Next Page
Loading...
